Milners Automotive Repairs Request a Service

The workshop

Gallery: our work by service

A look at the jobs we do, grouped by service. Tap any photo to see it larger.

Servicing & Repairs

Engine bay opened up for servicing, with the cam pulley and timing belt exposed A Ford Transit Custom in the workshop with the front end stripped down for engine work A diesel cylinder head lifted off in the engine bay, valves and rocker gear on show A car raised on the two post lift with its engine out and sitting on a pallet below The same Transit Custom from the side, front panel off and the engine open to work on The workshop tool wall, with cordless impact guns, grinders and sockets on the board

Diagnostics & Fault Finding

Live circuit testing on a car's front hub and suspension using a power probe Repairing a wiring connector on a vehicle's engine loom A laptop propped on the wing showing manufacturer torque data while the cam belt is set up

MOT Preparation

A Ford Transit up on the two post lift for an MOT check over An Audi saloon raised on the lift with the rear lights lit during a pre-MOT inspection

Service + MOT Prep

A Range Rover on the scissor lift, up for a service and MOT preparation

Brakes, Suspension & Exhausts

A Land Rover Defender raised on the two post lift with a wheel off, exposing the brake disc A Jaguar saloon on the scissor lift with all four wheels off and the hubs exposed

Clutches & Transmission

A clutch cover and flywheel exposed on an engine lifted out of the car An engine and gearbox bellhousing out of the vehicle and stood on a pallet

Timing Belts, Wet Belts & Chains

A cam belt change in progress, with the camshaft locking tools fitted Camshaft locking tools clamped to the pulleys while a new timing belt is fitted

Tyres

Checking tyre pressure sensor readings with a TPMS diagnostic tool The workshop tyre changer, set up for fitting and removing tyres from alloy wheels The wheel balancer used to balance a wheel after a new tyre is fitted A car up on the lift with a wheel off and the alloy stood on the floor for a tyre change

Software Updates & Coding

A car door control module circuit board removed for repair A window switch pack taken out of a car door for testing A manufacturer wiring diagram on the workshop screen while a van is worked on behind

Welding & Fabrication

A new braided flexi joint welded into an exhaust downpipe, held in the bench vice

4 Wheel Alignment

Four wheel alignment equipment clamped to a car's wheel on the alignment ramp The four wheel alignment cabinet and its wheel clamps stored on the workshop wall

Air Conditioning

Air conditioning service hoses connected to a car's system with the bonnet up

Like what you see?

Get your car booked into the workshop, request a service online and Milners will confirm your day by email.

Request a Service Call 07494 299387